No interference soldering station

Split design, small size easy for putting, space- saving Light handle and suitable for long-time operation

Characteristics and Advantages

Split design, small size, easy for putting,  space- saving in particular.

Light handle and suitable for long-time operation

Heater with imported temperature - beard  materials,  four-wire heating method, long life, and low cost.

Low-voltage power supply used on the  heater, anti-static, no creepage, no interference

Unique temperature locking devices to prevent the 

staff from adjusting the temperature improperly.

Temperature 200-480°C, stable and accurate

Same as the soldering tips of international brand;

Technical Specifications

Input Voltage: AC 110V/220V optional

Input Frequency: 50/60Hz

Power Consumption: 50W (max)

Temperature Range: 200 – 480°C

Tip and ground impedance: <2 Ohm

Tip and ground potential: <5mV

Standard tip: AT-900M

Parts List

ATTEN 907 handle	1PC
Soldering holder	1PC
Clean sponge	1PC
Heating elements	4 core,50W

ATTEN INSTRUMENTS

RF Microwave Instruments

RF Microwave Components

Spectrum Analyzers.Regulated DC Power Supply

Switching DC Power Supply.Digital Storage Oscilloscope

Signal Generator.Attenuator.Amplifier.850 Rework Station

936 Constant Temp Soldering Station

Electronic Instruments.Electronic Tools

Safety Precautions

Caution: Improper usage can cause serious injury to personnel and/or damage to equipment. For

personnel safety, please follow these precautions:

Never use it to do other work except soldering.

Do not subject the main unit to physical shock. Never drop or sharply jolt the unit.

Don't change the device at will

Replace loss items with original accessories of ATTEN.

Don't put it in water or operate with wet hands

Don't pull the cable but hold tightly the plug when you take it out of plug.

Please keep the operate place well ventilated since soldering process produce smoke.

Don't play with other people or would be easy to hurt others or yourself.

Care and Maintenance

Keep the soldering station dry; if it gets wet, dry it immediately.

Use the soldering station only in normal temperature environments.

Keep the soldering station away from dust and dirt.

The soldering iron tip should be cleaned after use by wiping it on the damp sponge found in the soldering iron stand. This is to get rid of burnt solder or fluxes that cause oxidation on the tip.

Changing Soldering Tip

Always turn the power OFF when removing or inserting a tip

Let the tip to cool down to room temperature before holding it with heat resistant pads

Unscrew the metal cap nut

Pull out the shaft of the soldering iron

Replace it with a new soldering tip.

Put back the shaft and securely lock with the metal cap nut

No interference soldering station